Bosch Kompakt-Dampfgenerator Sensixx´x DI90 AntiShine TDI903231A anthrazit metallic rosso rot - Manual (Page 18)

16
BOSCH
* Model dependent
EN
gl
ISH
Before using your appliance for the
first time
1. remove any labels or protective covering
from the soleplate (13).
2. If necessary, carefully clean the soleplate
down with a dry, folded cotton cloth.
When turned on for the first time, your new iron
may smell and emit a little smoke and a few
particles; this will stop after a few minutes.
☞ ☞ Tip: When using the steam function for the
first time, do not use it on your laundry, as
there may still be some residue in the
steam dispenser.
Hold the iron horizontally and repeatedly
press the shot of steam button (7). Some
residue may come out of the soleplate.
Using your appliance
1. Filling the water tank

See the leaflet sides
This appliance has been designed to use normal
tap water.
• The addition of other liquids, (unless
recommended by Bosch) such as perfume,
will damage the appliance.
• Do not use condensation water from tumble
dryers, air conditioning systems or similar.
any damage caused by the use of the
aforementioned products will make the
guarantee void.
E
Unplug the iron from the mains!
1. Open the water inlet lid (9).
2. Fill the water tank. Never fill beyond the
level mark for maximum filling (12).
3. Close the water inlet lid.
☞ ☞ Tip: To prolong the optimum steam
function, you may mix tap water with
distilled water 1:1. If the tap water in your
district is very hard, mix tap water with
distilled water 1:2. You can inquire about
the water hardness with your local water
supplier.
SensorSteam
2. “SensorSteam” function

See the leaflet sides
The “SensorSteam” function switches off the
iron when the handle is no longer gripped,
thus increasing safety and saving energy.
1. Plug in the appliance to the mains.
Initial heating up process: After plugging
in the appliance, this function will be inactive
until the iron heats up to the set temperature.
2. After the initial heating up period, the
“TempOK” lights inside the temperature
control (15) stop flashing and “eco” setting is
automatically selected.
3. From this moment on, when the handle (1)
of the iron is gripped, the “SensorSteam”
indicator lamp (3) stops flashing and the
iron switches on.
4. Immediately after releasing the handle of the
iron, the “SensorSteam” indicator light will
start flashing, indicating that the iron is about
to switch itself off.
5. When the handle is gripped again, the iron
will automatically switch itself back on and will
start heating up again.
If the iron is left unattended for more than eight
minutes, once the handle is momentarily or
continuously gripped again, the initial heating
up process will start again.
3. Setting the temperature

See the leaflet sides
The temperature control (15) adjusts the
temperature of the soleplate (13).
1. Start by ironing the fabrics that require
the lowest ironing temperature. Check the
recommended ironing temperature in the label
on the garment.
2. Set the temperature control (15) to the
corresponding position by lining it up with the
temperature index (14) on the iron.