PASCO ME-6962 PAStrack Systems - Manual (Page 4)

®
P A S t r a c k S y s t e m s A b o u t t h e E q u i p m e n t
4
This manual contains descriptions of the equipment included in the various systems,
complete instructions for nine experiments, and ten additional experiment sugges-
tions.
About the Equipment
PAStrack The PAStrack consists of two sections that can be
joined together with the included connector and split apart for
storage. Together the two sections form a 1 m track. An extra con-
nector is included, allowing any number of tracks to be joined
together.
To assemble the track:
1. Slide a connector piece into the “50 cm” end of one track sec-
tion. Push it hard until you hear it snap.
2. Slide the other track section onto the connector piece. Push it
until it snaps.
3. Turn the track upside down and tighten the screws on the con-
nector.
To level the track:
1. Set the track upright on a level surface.
2. Place a cart on the track to test it for level.
3. Adjust the feet to make the track straight and level.
4. Tighten the locknut of each foot.
To disassemble the track:
1. Loosen the connector screws.
2. Press and hold the release tabs on the bottom of the track.
3. Pull the track sections apart.
For more information, see the instruction sheet packaged with the track.
1
2
3
4
5
PAStrack Parts
1: Connector 2: Connector screws 3: Release tabs
4: Lock nut 3: Foot