Computer-based centripetal force accessory, Equipment list – PASCO ME-8089 Computer-Based Centripetal Force Accessory User Manual
Page 3

®
Model No. ME-8089
Centripetal Force Accessory
3
Computer-Based
Centripetal Force Accessory
Model No. ME-8089
Equipment List
*
PASPORT™ sensors (with PS-prefix) require a PASPORT™ interface PS-2100(2) or PS-2001(1) for operation. A Photogate
Port (PS-2123) is required for photogate use with PASPORT interfaces.
**
ScienceWorkshop
®
sensors (with CI-prefix) require a ScienceWorkshop
®
interface for operation.
Optional equipment: For constant speed studies, a Motor Drive (ME-8955) with DC Power Supply (SF-9584A) is
recommended.
Included Equipment
Model
Number
Additional Equipment
Required
Model
Number
1. Connecting Cable (1)
623-038
Rotating Platform
ME-8951
2. Ball Bearing Swivel, 12.5 g (1)
648-08386
A computer
N/A
3. Pivot block (1)
648-08422
DataStudio
®
Software
See PASCO catalog.
4. Thumbscrew for Pivot Block
(1)
617-003
Computer Interface
PASPORT
*
or
ScienceWorkshop
**
5. Sliding Mass Holder (1)
648-08423
Force Senso
r
PS-2104* or
CI-6746**
6. Mass, 100 g (2)
648-06511
Photogate Head/Port
ME-9498A, PS-2123
*
7. Screws for Mass Holders (2)
610-246
Steel Rod (45 and 90 cm or 120
cm)
ME-8736/ME-8738/
ME-8741
8. Stationary Mass Holder (1)
648-08424
Multi-Clamp
SE-9442
9. Nuts for Mass Holders (2)
614-006
Large Rod Base (2)
ME-8735
10. Thumbscrews (2)
613-067
Experiment Setup Disk
013-08425A
11. Mass, 50 g (4)
648-06510
6
1
4
3
5
2
7
8
9
10
11