Pach and Company AeGIS 8000 Series Manual - Manual (Page 27)

Chapter 4
SYSTEM’S OPERATION
Pach and Company Chapter 4 Page 20
AeGIS 8000 Series SYSTEM’S OPERATION
TO VIEW A TENANT NAME 1. Press 3 to view from A-Z
2. Press 6 to view from Z-A
TO INITIATE CALL AND UNLOCK THE DOOR
OR GATE Two ways to initiate a call:
1. USING A SCROLLING ELECTRONIC DIRECTORY
Step 1 Press 3 or 6 to scroll the tenant name, when the tenant name you
are intended to call is visible on the display, then press # to initiate
the call. The display will show
then it will show
Step 2 Press * to cancel the call, otherwise wait for the tenant to answer
your call
Step 3 Tenant must press 9 to unlock the door or gate.
2. A DIRECT CALL
You must know the tenant directory code to use a direct call.
Step 1 Press # and wait for a dial tone, the display will show
Step 2 Press the 2, 3 or 4 digit directory code, the system will initiate the
call.
Step 3 Press * if you want to cancel the call, otherwise wait for the tenant
to answer your call.
Step 4 Tenant must press the correspondent key to release the door. By
default press 9 to release door 1 (relay 1) or 8 to release door 2
(relay 2).
TO CALL THE SYSTEM The tenant can call to AeGIS 8000 system to communicate with their
visitor. Function Code 74 must be enabled and you must know the AeGIS
8000 telephone number
Step 1 Call the AeGIS 8000, you will “two short beeps” if the call is
connected.
Step 2 Press
*
now you re communicating with the AeGIS system.
Step 3 You can press the associate key to unlock the door or hang-up.
TO EXTEND THE TALK TIME WHILE
COMMUNICATING WITH THE AeGIS 8000 The talk time can be programmed from 10-180 seconds, refer to function
code 79. Ten seconds before the talk time expire, you will one long beep.
The tenant must press # to extend the talk time to another cycle.
TO PROVIDE REMOTE ACCESS Press 9 to unlock door 1 or 8 to unlock door 2 by default. You can
change the remote access number, see function code 20 and 21.
TO CALL TO A VOICE MAIL OR EXTENSION Press the voice mail or extension number after the call is connected.
WAIT. . . DIALING
Wait for Answer
DIR CODE: