Pach and Company AeGIS 8000 Series Manual - Manual (Page 21)

Pach and Company Chapter 3 Page 14
AeGIS 8000 Series PROGRAMMING
FUNCTION CODE PROGRAMMING
Step 4 Proceed to step 2 and select the same function code or different
function code to continue programming or press
*
to exit the
programming mode and you will hear “ three short beeps”.
16
VERIFY THE CURRENT DATE
Step 1 Log on to programming mode, see instruction above. The display
will show
Step 2 Enter function code 16 then press #, the display will show the
current date for about 3 seconds
Step 3 Proceed to step 2 and select the same function code or different
function code to continue programming or press
*
to exit the
programming mode and you will hear “ three short beeps”.
17
SET SYSTEM’S DATE
Step 1 Log on to programming mode, see instruction above. The display
will show
Step 2 Enter function code 17 then press #, the display will show
then it will show
Step 3 Enter the current date then press #
MM = Current month DD = Current date
YYYY = Current Year
D = Current day (1=Mon, 2=Tue, 3=Wed, 4=Thu, 5=Fri, 6=Sat
7=Sun).
Step 4 Proceed to step 2 and select the same function code or different
function code to continue programming or press
*
to exit the
programming mode and you will hear “ three short beeps”.
19
INITIALIZE EVENT RECORDING
The event buffer will hold up to 600 events.
Download the events via software and and save
them into your hard-drive. Then clear the even
buffer. It will save your time to download the
next events.
Step 1 Log on to programming mode, see instruction above. The display
will show
Step 2 Enter function code 19 then press #, the display will show
Step 3 Enter • 1 = clear the events buffer
• 0 = cancel deletion then press #.
Step 4 Proceed to step 2 and select the same function code or different
function code to continue programming or press
*
to exit the
programming mode and you will hear “ three short beeps”.
Select Func: _ _
FRI JAN. 17, 2003
Select Func: _ _
Enter date
Date: MMDDYYYYD
Select Func: _ _
InitEVR (0,1): _