Send buttons function receive buttons function – Pach and Company AeGIS NPB9000P Series Software manual User Manual
Page 21
Pach and Company
Chapter 5
Page 16
AeGIS 9000 Series Management Software
BUTTONS AND MENU
03/01/02
Figure 5.4
[Clear Tenant]
Enter the 2, 3 or 4-digit code to be deleted in the text box
or enter 0000 to clear all tenants in the system, click the
[clear Access Code] or press
Note: The button does not delete an individual tenant or
tenant database file in your computer. You must
delete them separately.
[Card Fac.Code]
Enter the card reader facility code (000-255) in the text
box and click [Card Fac.Code].
[CallHoldTime]
Enter the call hold time (010-240 seconds) in the text
box and click [CallHoldTime] or press
[Door1Opentime]
Enter the door 1 open time (04-99 seconds) in
the text box and click [Door1Opentime] or press
[Door2Opentime]
Enter the door 1 open time (04-99 seconds) in
the text box and click [Door2Opentime] or press
[LockOutCount]
Enter the lock out count (1-9) in the text box and click
[LockOutCount] or press
[SystemID]
Not applicable.
[ManualIUnlockDoor1]
Enter (01-98 hours or 99=indefinite time).
[ManualIUnlockDoor2]
Enter (01-98 hours or 99=indefinite time).
[Relay2Mode]
Enter 1=Door Control, 2= A Shunt, 3= An Alarm Switch,
4= A CCTV Switch.
[PBX No]
Enter the number up to 5-digit. If the AeGIS 9000 Series
is connected to the PBX extension port to dial out you
have to get the outside line (PBX No) before dialing the
actual phone number.
[NewMasterCode]
Enter a new master code to replace the existing one.
[PAR]
AeGIS 9000 Series parameters. Click this button and the
system’s parameters shows in the Received Content
window.
[TNT]
Click this button to receive the tenant database from the
AeGIS 9000 Series. The database can be saved into a
file or display in the Received Content window.
To Save into a file:
Click the [TNT], a small window pops then type the file
name then click [Open] and then click [Please close log
file after receiving], the database will be save into the
file with TNT extension.
To display in the Received Content window:
Click the [TNT], then a small window pops and click
[Cancel].
SEND BUTTONS
FUNCTION
RECEIVE BUTTONS
FUNCTION