Nova-Tech GC Indicator - Manual (Page 36)

P a g e 34 © Adam Equipment Company 2010
12.2.8 F8 –ADC COUNTS
• To enter this parameter, press the [Tare] key when “F8” is shown.
• This parameter allows you to view the A/D counts from the internal A/D
converter. This can be an aid to service.
• Press the [Tare] key to return to the PARAMETER menu.
• Press the [Zero] key to return to weighing.
• Typical value at zero is 30,000-90,000 (approx.) Typical value at full
capacity is 500,000 (approx.)
12.2.9 F9 –PIN
This parameter allows setting of password to enter the user parameters, see section
12.1. The default value is “0000”.
• To enter this parameter, press the [Tare] key when “F9” “Pin” is shown.
• The “Weight” display will show “Pin 1”
• Enter the new password. The “Unit Weight” display will show dashes.
Press [Tare].
• The “Weight” display will change to “Pin 2 “, Enter the password again
and press [Tare].
• The display will show “donE” indicating the new password has been
accepted and will return to the menu. “F9” “Pin” is shown. Record the
new password in a secured place.
• Press [Zero] to return to weighing.
12.2.10 F10 –LOW VOLTAGE DETECTION
• This parameter allows detection of low voltage when the battery wears
down.
• To enter this parameter, press the [Tare] key when “F10” is shown.
• The display will show if the LVD Mode is set to “on” or “oFF”.
• Press the [U.Wt./Units] key to change the value.
• Press [Tare] to accept the displayed value.
• Press [Zero] to return to weighing.