Nova-Tech GC Indicator - Manual (Page 35)

P a g e 33 © Adam Equipment Company 2010
• The display will tell you to add the second weight to the scale: “LoAd 2 “
100” “kiloS”
• Remove the weight.
• The display will show “SPAn” “PASS” if the calibration is OK. Or it will
show “SPAn” “FAIL” if calibration could not be completed correctly. After
calibration the scale will return to normal operation. If you wish to set
any of the following parameters enter the Service menu again and skip
the first settings by pressing the [U.Wt./Unit] key.
12.2.5 F5 –INITIAL ZERO RANGE
• To enter this parameter, press the [Tare] key when “F5” is shown.
• The display will show the current initial zero range.
• Press the [U.Wt./Units] key to change the value and press [Tare] to
accept the value.
• Press [Zero] to return to weighing.
12.2.6 F6 -RE-ZERO RANGE
• To enter this parameter, press the [Tare] key when “F6” is shown.
• The display will show the current re-zero range.
• Press the [U.Wt./Units] key to change the value.
• Press [Tare] to accept the value.
• Press [Zero] to return to weighing.
12.2.7 F7 -SUCCESSIVE TARE
• To enter this parameter, press the [Tare] key when “F7” is shown.
• The display will show if the successive tare is on or off.
• Press the [U.Wt./Units] key to change the value.
• Press [Tare] to accept the displayed value.
• Press [Zero] to return to weighing.