Diamond Products SB User Manual
Page 37
SB Wire Sawing System
Run up wire saw
SB_0107_e.mif
Page 37
3XOO ZLUH WKURXJK E\ KDQG
l
Before starting the wire saw pull the wire by
hand over the building object
6ZLWFK RQ GULYH XQLW
l
See the operating instructions for the drive
unit being used.
3UHVHWWLQJ WKH IHHG
Before first switching it on, the wire must be
tensioned by means of the feed as follows:
1. Not too loose. Otherwise the wire will not start to run
or it could even jump off the pulleys.
2. Not too tight. Otherwise the wire could dig into and
bind in the corners of the structural body.
l
Set selection switch (4) to anticlockwise
l
Preset feed pressure to 30 bar with rotary
controller (1)
/HWWLQJ WKH ZLUH UXQ
l
Press the "ON" pulsing button on the
remote controller
If the wire cannot be pulled over the building
object by hand it will also not be able to start
up with the machine!
If the wire does not start to run immediately
switch off the machine again, search for the
reason why the wire is not moving and rec-
tify it.
(See Page 38: Rectifying faults)