Diamond Products SB - Manual (Page 33)

SB Wire Sawing System Insert wire
SB_0107_e.mif Page 33
,QVHUW ZLUH
,QVHUW ZLUH JHQHUDO :LUH UXQQLQJ GLUHFWLRQ
The wire running direction is prespecified by
the running direction of the hydraulic motor
and the design of the drive pulley (free-
running) and cannot be changed.
Before any work is carried out on
the SB the plug on the drive - if
connected - must be withdrawn.
The wire can be inserted into the machine
open (unpressed) or closed (pressed).
Note the running direction of the wire. This
is always shown by an arrow on the wire.
If the running direction arrow can no longer
be seen on a worn wire, the small diameter
of the conically-worn beads must be aligned
to the front.
Do not change the running direction of the
wire (by inserting the wire in the opposite
direction), since this would cause increased
wear.