Diamond Products SB - Manual (Page 24)

The diamond wire SB Wire Sawing System
Page 24 SB_0107_e.mif
7KH GLDPRQG ZLUH
,QWURGXFWLRQ
These operating instructions describe 2 con-
necting elements for 2 different types of wire.
:LUH W\SHV
We distinguish between sintered wire of 11
mm diameter and electro-plated wire. (See
page 27) SB_0107_e.fm.
l Only use the original TYROLIT connectors
for assembly and the original TYROLIT
tools, which are provided, for the fitting of
these connectors
l Never kink the wire!
l If the wall thickness is less than 80 cm oper-
ate with reduced pressure to limit the wear
on the beads
&RQQHFWLQJ HOHPHQWV
Both wires can be connected or repaired with
the following connecting elements:
- Repair sleeve
- Knuckle connection
6WRUDJH RI ZLUH
l After use clean the wire and always make
sure it is stored dry and protected from the
light
The screw connection should not be used
with the SB!
It leads to increased wire cracks!