MP Pumps HTO 180 INSTALL - Manual

HTO 180 INSTALLATION AND SERVICE INSTRUCTIONS
This bulletin must be read completely before installing, operating, or servicing the pump.
WARNING:
If any of the items listed below are violated, serious injury or death from burns caused
by hot oil may occur.
DO NOT perform service or maintenance when
the pumping system is pressurized or hot -
serious injury or death from burns caused by
hot oil may occur.
DO NOT operate the pump in a manner that it
was not intended to be used.
DO NOT install for use in an open environment
where people are present.
DO NOT install in a rigid piping system that does
not allow the pipe to expand and cause the pump
to be strained.
DO NOT continue to operate the pumping
system when a know leak exists or the system
continues to smoke.
DO NOT continue to operate the pump when
unusual noise or vibration occurs.
DO NOT install or use near water where the
pumping system may come into contact with
water or is splashed by water.
MP PUMPS HTO SERIES
DO NOT operate beyond the pressure or
temperature limits stated in the product literature.
(See Form 9001)
DO NOT allow severe temperature changes to
occur in a short time period within the pumping
system.
DO NOT mix different types or grades of oil
within the oil system.
DO NOT use an oil that is not a recommended
heat transfer oil by the manufacturer.
DO NOT exceed the maximum oil temperature
rated by the oil manufacturer at the hottest point
in the pumping system.
DO NOT mount the pump such that high piping
loads exist on the pump flanges.
FORM 3073 (9-04)
!