MP Pumps PETROLEUM SELF-PRIMING 5, 8, 10, 15 INSTRUCTION - Manual

Do not install a piping system that does Do not continue to operate the pumping
not allow for any flex due to expansion from system when unusual noise or vibration
Do not allow severe temperature changes Do not perform service or maintenance
pumping system.
Drain pump completely before switching Do not mount pump in conditions that high
PO Biodiesel, Diesel and Fuel Oil.
PG Gasoline, Kerosene, Avgas
Jet A and JP 8 Fuel.
PE Ethanol and E-85.
occurs.
Do not continue to operate the pumping
system when a known leak exists or the
system starts to smoke.
or hot.
FORM 3074-A (2/08)
fuel type that is to be pumped. piping loads exist on the pump flanges.
WARNING!
to occur in a short time period within the when the pumping system is pressurized
Do not operate the pump in a manner that
it was not intended to be used.
heat generated by the pumping system.
PRINTED IN THE U.S.A.
MODELS:
This pump was designed to handle volatile and flammable fluids. To reduce the risk of fire or
explosion keep pump in well ventilated area free of explosive atmosphere. Do not smoke where
the fuel is being handled, also keep away from any sparks or open flame. Do not operate pump
with either the suction or discharge valves fully closed as this will over heat the pump. If pump
becomes overheated allow to cool before next use.
PETROLEUM SELF-PRIMING CENTRIFUGAL PUMPS
INSTRUCTION BULLETIN
Read this bulletin in full before installing, operating or servicing this pump. If any of the warnings of
this bulletin are ignored serious injury or death could occur.