MP Pumps PETROLEUM 8 - Manual

PETROLEUM 8
2" x 2" Self Priming Centrifugal Pump
Petroleum 8 self-priming centrifugal pumps are capable of creating vacuum
sufficient to lift liquids from heights up to 25 feet above the source. To
handle many different fuels, the Petroleum 8 is available in three distinct
models: PO, PG and PE 8.
A Petroleum 8 PumPAK
®
is a fully assembled and run tested pump end
that can be easily coupled to a number of drivers such as hydraulic
motors, 56C and 145TC frame motors and gas engines. A bearing pedestal
is also available for T-frame motor or belt drive.
Standard features include SS drive sleeve, SS fasteners, renewable wear
plate, and a semi-open dynamically balanced impeller.
The Petroleum 8 Pump is available in three distinct models: PG, PO and
PE
Model PG Pumps - Compatible For Gasoline, Kerosene, Avgas & Jet Fuel
Model PO Pumps - Compatible For BioDiesel, Fuel Oil & Diesel
Model PE Pumps - Compatible For Ethanol & E 85
SPECIFICATIONS:
Suction and Discharge . . 2" x 2" NPT
Flow . . . . . . . . . . . . . . . Up to 150 GPM
Head Feet . . . . . . . . . . . Up to 100'
Impeller . . . . . . . . . . . . PE 8 - semi-open cast iron, 316 SS (optional)
PG 8 - semi-open cast iron, aluminum (optional)
PO 8 - semi-open cast iron
Motor . . . . . . . . . . . . . . Up to 3 HP
Drive Options . . . . . . . . Close coupled 145TC
Close coupled 56C
Engine mount 5.5 HP
Engine mount 6.5 HP
Hydraulic motor .22 cu. in.
Hydraulic motor .37 cu. in.
Hydraulic motor .45 cu. in.
Pedestal
PumPAK
®
(without motor)
Seal . . . . . . . . . . . . . . . PE 8 - carbon / silicon carbide / Viton
PG 8 - carbon / silicon carbide / Viton
PO 8 - carbon / Ni-Resist / Viton
Application:
Agricultural •
Industrial •
Marine •
OEM •
Compatible For:
PE 8 - ethanol, E 85 •
PG 8 - gasoline, avgas, kerosene, jet A/8 •
PO 8 - biodiesel, fuel oil, diesel •
Features:
Gas engine for diesel fuel transfer •
Non-spark clamp (on some models) •
Renewable wear plate •
Stainless steel drive sleeve •
Stainless steel fasteners •
Up to a 25' suction lift •
Mounting Options:
PE 8 - explosion proof, class 1, group D •
PG 8 - explosion proof, class 1, group D •
PO 8 - TEFC •
Options:
5 blade impeller available for higher flows •