MP Pumps PETROLEUM SELF-PRIMING 30, 40 INSTRUCTION - Manual

SIZE: 30 AND 40
next use.
Do not install a piping system that does Do not continue to operate the pumping
not allow for any flex due to expansion from system when unusual noise or vibration
Do not allow severe temperature changes Do not perform service or maintenance
pumping system.
Drain pump completely before switching Do not mount pump in conditions that
flanges.
PO : Diesel, Biodiesel
and Fuel Oil
PG : Gasoline, Kerosene,
AV Gas, and Jet Fuels.
PE : Ethanol and E-85
PRINTED IN THE U.S.A.
pressurized or hot.
FORM 3075-A (6/08)
Do not continue to operate the pumping
system when a known leak exists or the
system starts to smoke.
WARNING!
to occur in a short time period within the when the pumping system is
Do not operate the pump in a manner that
it was not intended to be used.
heat generated by the pumping system.
Read this bulletin in full before installing, operating or servicing this pump. If any of the warnings
of this bulletin are ignored serious injury or death could occur.
MODELS:
This pump was designed to handle volatile and flammable fluids. To reduce the risk of
fire or explosion keep pump in well ventilated area free of explosive atmosphere. Do
not smoke where there is fuel being handled, also keep away from any sparks or open
flame. Do not operate pump with either the suction or discharge valves fully closed
as this will over heat the pump. If pump becomes overheated allow to cool before
occurs.
fuel type that is to be pumped. high piping loads exist on the pump
PETROLEUM SELF-PRIMING CENTRIFUGAL PUMPS
INSTRUCTION BULLETIN