Micromod MOD: Modcell 2050R MODBUS Communications - Manual (Page 27)

IB-23C650M
RS-485 COMMUNICATIONS SETUP
Table 1. RS-485 Setup Menu
Middle
Display
Bottom
Display
Entry Description
OUT2 VAL XXX Where X = any value between 0 and 100%.
This is the output 2 value the controller will
have if the retransmission variable in the "MA
OUTP MENU" has been selected as manual or
computer only and a computer failure has been
detected.
RELAY A LAST
OFF
ON
= relay state remains as it was prior to the
detection of a computer fail.
=relay goes to off state after a computer fail.
=relay goes to on state after a computer fail.
RELAY B LAST
OFF
ON
= relay state remains as it was prior to the
detection of a computer fail.
=relay goes to off state after a computer fail.
=relay goes to on state after a computer fail.
RELAY C LAST
OFF
ON
= relay state remains as it was prior to the
detection of a computer fail.
=relay goes to off state after a computer fail.
=relay goes to on state after a computer fail.
SPT MODE LAST
LOCAL
LOCAL-2
LOCAL-3
LOCAL-4
REMOTE
= controller uses the same set-point source
after a computer fail has been detected.
=Selecting any other set-point source causes
the controller to use the selected set-point after
a computer fail has been detected.
Note: The local set-points need not be enabled
in the "SETPTS MENU" for this use. If
ramp/soak is running at the time of a computer
fail, and a mode other than LAST has been
selected, ramp/soak will discontinue.
23