Micromod Micro-DCI: 53SU6000 COMMUNICATIONS SERVICES - Manual (Page 29)

53SU6000 INSTALLATION AND SETUP GUIDE
Introduction 21
• If you are upgrading or reinstalling a 53SU6000 over an existing 53SU6000, a window will
appear at this time asking if you would like to add any networks (Micro-DCI instruments)
now. If you would like to add Micro-DCI instrument networks, click on the Yes button.
3.5.8 Adding Micro-DCI Networks
• The Add Micro-DCI Networks window appears. Click the Next button.
• The Setup program then starts the Super32 program, which is a 53SU6000 program that
enables you to add Micro-DCI network instruments to your system. This is a good time to add
Micro-DCI networks to your system since you need to reboot your PC after installing the
53SU6000 software and after you install the Micro-DCI networks.
• The first Network Wizard window lets you select whether you are adding a network that is
connected to your system through a supervisor board (SUP) or though a COM port (COM).
Select either SUP or COM. Then click the Next button.
• In the Network Wizard - Network Attributes window, enter a Network Name (up to 9
characters) and select a Network Position. Then click the Next button.
• The Network Wizard - Backup window appears. Select Master or Backup, and then click the
Next button.
• The Network Wizard - Network Parameters window appears. Set the I/O Port Address to
agree with the address jumpers on the Supervisor board as shown in
Table 3-2 .
• The parameters change depending on the type of network that is being installed.
• After selecting the port, click the Next button.
• In the Network Wizard - Finish window, click the Finish button.
• A window appears stating that you need to reboot your computer for the system to recognize
the newly added SUP Micro-DCI networks. Click the OK button.
• If the network was added successfully, Super32 will ask if another network is to be added. If
so, repeat the above steps until all desired Micro-DCI networks have been added. Answering
No exits Super 32 and returns you to the Main 53SU6000 Setup program.
• At this point the Notepad application opens and a 53SU6000 Read Me file appears containing
53SU6000 release information. When you have finished reading this document, close
Notepad.
• Setup will now ask if you want to restart the PC.
• Select Yes and then click the OK button to restart the PC.
• This completes the setup process.