Meriam M203 Altimeter Indicated Air Speed Tester - Manual (Page 21)

18
Data Logging
Data Logging can be used to record pressure measurements. Two record modes
are supported: automatic and manual. In automatic mode, a pressure value is
captured every 5 seconds for 20 minutes, resulting in 240 stored values. In
manual mode, a pressure value is captured each time the PRGM key is pressed
up to 240 values. The data collected during a logging session can be viewed upon
completion.
Keystroke Display
1. From the Measure Mode,
press the PRGM key. Top line reads “PROGRAM
MODE” and bottom line reads
“UNITS SELECT”.
2. Press the ▲ key five times. Bottom line reads “DATA
LOGGING”.
3. Press the PRGM key. Top line reads “DATA
LOGGING” and bottom line
reads “RECORD”.
4. Press the PRGM key. Top line reads “RECORD
MODE” and bottom line reads
“AUTO” or “MANUAL”.
5. Press the PRGM key at
AUTO to start automatic
logging or at MANUAL to start
manual logging mode. Top line reads
“RECORDING X” and bottom
line reads “XX.XX UNITS”.
AUTO records value every 5
seconds. Manual records value
each time PRGM key is
pressed.
6. To stop recording values at
any time, press the
◄ key.
Top line reads “DATA
LOGGING” and bottom line
reads “RECORD”.
7. To access recorded values,
press the
▲ key.
Top line reads “DATA
LOGGING” and bottom line
reads “VIEW”.
8. To view recorded values,
press the PRGM key. Top line reads “DATA LOG: 1”
and bottom line displays the
value. Continue pressing the
◄
key to view all values.
9. Press the ◄ key 3 times. Returns to Measure Mode.
The Auto Shut-Off” timer is disabled for Data Logging
sessions. Be sure to end the session to re-enable the Auto Shut-Off timer.