Mallory Ignition ACCEL POWER PROCESSOR 79100 - Manual (Page 9)

Power Processor
9
Please ready these instructions carefully before using your
Accel/DFI Power Processor.
Installation - Cautions and Warnings
1 – Always follow safety & installation guideline and precautions when installing this or any
other performance related component.
2 –Test system for proper operation after completing instillation.
3 – Always apply emergency brakes when working on vehicle.
PROGRAMMING INSTRUCTIONS
To select your options and parameters
Use Up – Down Arrow keys to change options
Use Left – Right Arrow Keys to pick selections
1. Set the parking brake. Locate the Data Link Connector (ALDL) under the
driver’s side of the dash panel near the right knee position. (In most cases)
2. Plug the Processor cable into the ALDL Port. Make sure the cable is plugged in
completely to ensure a good connection.
The Processor will prompt you to turn the ignition key ON and press OK so it can
check vehicle ID, but do not start the engine. It will then identify your vehicle and
ask you to turn the ignition OFF and press OK.
3. A display of vehicle options will appear on its screen. Select the vehicle you
have. Press OK (If an Unsupported Vehicle message appears, see page 5,
Trouble Shooting Section).
4. Next, select Power Program, press ok, and choose from the 3 Levels of Power
Tunes that are supplied or select the Advanced Tuning option to input your own
parameters with the available power tunes. (Use the Flow Chart on page 6 -7 as a
guide).
If you have selected a supplied Power Tune (Max Performance 93 Octane
– Performance 91 Octane – Street 87 Octane.
5. Than press ok and follow the instructions on screen.
6. If you selected Advanced tuning: Select one of the three Power Tune
Options.