Mallory Ignition ACCEL POWER PROCESSOR 79100 - Manual (Page 5)

Power Processor
5
After stock program is downloaded, start engine and let run for 1 minute, then
shut engine off, disconnect battery for 15 seconds, reconnect battery, now, you
are ready to go to the Dealer/Repair Shop.
The Repair Facility has no way to find out if you have used a Power Programmer
once you download your stock program back in. It does not leave a Foot Print.
A P1000 code will set after uploading a program from the Power Processor which is
the same as disconnecting the battery.
• Multiple Programs or Stackers. IT WILL BE A PROBLEM if you attempt to
use this Processor’s tuning on top of an existing aftermarket program, that is
called stacking and will cause programming problems. If you purchased a vehicle
that already has a custom program, you must first reflash the PCM to stock before
using the Accel/DFI Power Processor.
• Computer Chips. Some aftermarket performance companies, offer a
performance chip that can be installed on the PCM, or in line with the com cable.
These chips will have to be removed prior to plugging the Power Processor, failure
to do so will cause the Processor not to recognize your vehicle application. A (Error
in opening file) will appear on the screen.
Safety Tips, Please read
•
It is the responsibility of the purchaser to follow all guidelines and safety procedures supplied
with this product and any other manufactures product used with this product.
Follow all recommended safety guidelines from this and other manufacturer’s installation
guides.
It is also the responsibility of the purchaser to determine compatibility of this device with the
vehicle and other components.
•
Accel DFI Corporation assumes no responsibility for damages resulting from accident,
improper installation, misuse, abuse, improper operation, lack of reasonable care, or all
previously stated reasons due to incompatibility with other manufacturer’s products.
•
Accel DFI Corporation assumes no responsibility or liability for damages incurred from the
use of products manufactured or sold by Accel DFI Corporation on vehicles used for
competition racing.
•
Accel DFI Corporation neither recommends nor approves the use of its products on vehicles
which may be driven on public highways or roads, and assumes no responsibility for damages
incurred from such use.
•
It is the purchaser’s responsibility to check the state and local laws pertaining to the use of
this Power Processor. Accel DFI Corporation does not recommend nor condone the use of its
products for illegal street racing.
• Installation of this product signifies that you have read this document
and agree to the terms stated within.