Mallory Ignition LAKEWOOD REAR DRIVE SHAFT SAFETY LOOP 18024 - Manual

1 LAKEWOOD www.lakewoodindustries.com
INSTALLATION INSTRUCTIONS
PART NO. 18024
2010 CAMARO REAR DRIVESHAFT SAFETY LOOP
FORM 47146783 11/10
LAKEWOOD CHASSIS AND SUSPENSION PRODUCTS ARE ENGINEERED AND MANUFACTURED TO IMPROVE THE PERFORMANCE OF YOUR VEHICLE.
WE ENCOURAGE YOU TO ENJOY USING OUR PRODUCTS SAFELY AT A SANCTIONED RACING FACILITY. PLEASE OBEY ALL TRAFFIC LAWS.
1. Properly raise and support vehicle either on automotive lift or
place on ramps.
Note: the use of jack stands to perform this installation is not
recommended.
2. Locate and remove factory installed fasteners from rear
tunnel brace.
3. Identify right and left side driveshaft safety loop mounting
brackets.
Note: larger end of bracket faces rearward.
4. Using factory bolts, install brackets between body and
factory tunnel brace or use Lakewood tunnel brace part
no. 20110. Do not fully tighten fasteners at this time.
5. Place loop up and over driveshaft and move away from work
area.
6. Install loop cross brace onto brackets using hardware
supplied in installation kit. Be certain that cross brace offset
is to rear of vehicle and that left side of cross brace is inboard
of left mounting bracket whereas right side of cross brace is
outboard of right mounting bracket. ( see photo of assembly)
7. At this point all fasteners can now be tightened.
8. Move loop into place and install using hardware supplied in
installation kit.
9. Tighten loop fasteners to complete installation.
LAKEWOOD IS A TRADEMARK OF PRESTOLITE PERFORMANCE
10601 MEMPHIS AVE #12, CLEVELAND, OH 44144
216.688.8300
FAX 216.688.8306
FORM 47146783
11/10
Made in U.S.A.
Printed in U.S.A.
Thank you for your purchase from Lakewood Industries. For
technical assistance, please call 216-688-8300 Monday thru
Friday 8:30 AM to 5:00 PM EST.
WARNING: DUE TO THE TECHNICAL NATURE OF THIS PRODUCT,
AND SPECIALIZED EQUIPMENT, PROFESSIONAL INSTALLATION IS
RECOMMENDED.
CAUTION: INSTALLATION OF THIS PRODUCT REQUIRES WORKING
UNDER THE VEHICLE. IT IS THE RESPONSIBILITY OF THE INSTALLER TO
ENSURE A SAFE WORKING ENVIRONMENT. THE USE OF AN AUTOMOTIVE
LIFT IS RECOMMENDED. MAKE SURE THAT THE VEHICLE IS SAFELY
SUPPORTED AND ALWAYS WEAR SAFETY GLASSES.