Mr. Gasket 3830 Carb Linkage Kit: Universal User Manual
Universal carb linkage, 3830g, Installation instructions
UNIVERSAL CARB LINKAGE
INSTALLATION INSTRUCTIONS
Step 1
1. Insert pin “A” through hole in bracket “B”.
2. Slide bracket “B” over rod “C”.
3. Attach pin “A” to front carburetor using washers “D” and “E”.
4. Insert cotter pin “F” to secure linkage to front carburetor.
Step 2
1. Attach heim joint “G” to rod “C” and lock in place with nut. (Fine adjustments
in linkage are made with the screw feature of the heim joint. It is suggested the
“locking” step be performed last.)
2. Slide adapter “H” onto rod “I”.
3. Attach heim joint “G” to adapter “H” by inserting bushing “J” and tightening
with screw “K”.
4. Place washer “L” on adapter “H” and insert through linkage arm on second
carburetor.
5. Insert linkage bushing “M” on carburetor side of linkage arm and tighten with
nut “N”.
PRIMARY ADJUSTMENT
A. Attach adjustment bushing “O” to rod “C” for simultaneous carburetor
opening. Slide bushing “O” on rod “C” until the bushing butts against bracket
“B”. Tighten screw-in bushing.
B. For progressive carburetor opening, insert pin “A” through hole “P” on
carburetor linkage arm on first carburetor only. Attach washers on pin “A” for
spacers and insert cotter pin “F”.
FINE ADJUSTMENT
Adjust bushing “O” and lock nut on heim joint “G” until desired operation is
achieved.
3830G
F
D
E
D
B
O
C
A
G
J
K
H
I
N
M
P/N 97143830
©2000
Cleveland, Ohio
216.688.8300
www.mrgasket.com
Inst. Sht. 3830 9/10/02 1:04 PM Page 1