Magnum Venus Plastech UPMS-1000 Monitoring System - Manual (Page 20)

OPERATIONS MANUAL
UPMS-1000-XXX
MAGNUM VENUS PLASTECH REV 1.02
NOVEMBER 2010 PAGE 20
TOTAL A
Cycle display using the MODE button, until the
TOTAL A is displayed.
Press and hold the ENT button until the display enters program mode. At this point you should see
KFT
A VALUE , with a number underneath it. The first digit should be blinking.
Press SEL until the decimal point is blinking. Using the UP or DN button, move the decimal until 3
decimal places are set. Then, using the SEL and UP and DN buttons, set the KFT A VALUE to the
appropriate value. At this point .500 should be used. The KFT A VALUE will be set in the Calibration
section.
Press ENT
to accept KFT A VALUE setting. This will then move to the next screen.
Set the
ENG UNITS A display by using the UP or DN and SEL buttons. Either set to KG, GR, LBS or
OZ.
Note: Remember what measurement was setup to display. This is the measurement that needs to be used
during the calibration process.
Press ENT
to accept ENG UNITS A setting. This will return you to the TOTAL A display.
TOTAL B
Cycle display using the MODE button, until the TOTAL B is displayed.
Press and hold the ENT button until the display enters program mode. At this point you should see
KFT
B VALUE , with a number underneath it. The first digit should be blinking.
Press SEL until the decimal point is blinking. Using the UP or DN button, move the decimal until 3
decimal places are set. Then, using the SEL and UP and DN buttons, set the
KFT B VALUE to the
appropriate value. At this point .500 should be used. The KFT A VALUE will be set in the Calibration
section.
Press ENT to accept
KFT B VALUE setting. This will then move to the next screen.
Set the
ENG UNITS B display by using the UP or DN and SEL buttons. Either set to KG, GR, LBS or
OZ.
Note: Remember what measurement was setup to display. This is the measurement that needs to be used
during the calibration process.
Press ENT to accept ENG UNITS B setting. This will return you to the TOTAL A display.