Magnum Venus Plastech HIS Troubleshooting Manual - Manual (Page 30)

Page 28
H.I.S. Troubleshooting Manual
Hardened area will
generally be confined to
ship section (1/4” x 34”
hose). If resin is in a
gelled state, it is possible
this can be pushed
through, using pump
pressure and then flushed
clean with solvent. If resin
is hardened, remove and
replace hose.
Catalyst hose plugged. Contamination Make sure lid is on
catalyst jug at all times.
Maintain clean supply of
catalyst. Be sure screen
is intact and clean on end
of catalyst gravity flow
hose. When catalyst
pump has been
dismantled, be sure all
parts are clean and free of
any foreign particles.
Catalyst flow area through
homes is very limited and
can be restricted by any
foreign matter.
Catalyst leak back through
gun Remove hose fittings on
ends of catalyst hose and
make sure small orifices in
fittings are free and clear.
If necessary, remove
catalyst hose core, wash
clean with clear water.
See Catalyst Pump and
General Trouble Shooting;
‘Catalyst hose plugged’ &
‘Gun head plugged on
catalyst side’.
CHAPTER 12:
Instructions and Procedures for Filled Resin Systems:
Certain processes and economic factors may call for a filler of some type (such as
calcium carbonate, alumina trihydrate, glass bubbles, shell flour, etc.) to be used