Magnum Venus Plastech HIS Troubleshooting Manual - Manual (Page 16)

Page 14
H.I.S. Troubleshooting Manual
outlet, push forward on
trigger to flush resin cavity
out front plug hole on resin
side. Visually examine
mix chamber for
cleanliness. Hang gun
with mix chamber down
until next use. For
overnight or weekend
inactivity, use the
following procedure:
remove nozzle cap,
turbulent mixer or static
mixer. Clean these parts
rinsing with solvent by
pushing forward on the
trigger. Additionally, flush
mix chamber. Remove
front plug on resin side of
gun head. With finger
over nozzle outlet, push
forward on trigger to flush
resin cavity out front plug
hole on resin side.
Examine visually the mix
chamber and resin
chamber for cleanliness.
Remove side plug from
catalyst side of gun head
and with clean rag or
paper towel, blot excess
catalyst off gun to prevent
fume generated curing of
any un-purged resin.
Hang gun with mix
chamber down. Before re-
start of unit, inspect
catalyst cavity and resin
cavity for evidence of
leakage. Also inspect mix
chamber for signs of
solvent leakage.
Resin fan without catalyst Cavity on catalyst side of
gun has gelled or
hardened resin. Remove front plug and
side plug from catalyst
side of gun head. Pick
gelled and hardened resin