Magnum Venus Plastech HIS Troubleshooting Manual - Manual (Page 12)

Page 10
H.I.S. Troubleshooting Manual
Keep pump vertical in
related holes. Increase
setting if gel time is too
slow.
Cold resin For best results of material
usage, keep material at
78
º F. (25º C). Proper
temperature control of
resin should be physically
checked with thermometer.
Low room temperature Maintain an even room
temperature of
approximately 70º F. Mold
should be ion draft free
location.
Auxiliary heat directed on
lay-up can be used to
hasten gel time.
Run out (SAG) Resin Consult resin supplier for
proper gun type resin and
different thixotropic
qualities.
Excessive gel time Increase percentage of
catalyst to shorten gel
time.
Excessive misting Resin Reduce power head
pressure.
No resin fan Obstruction in resin filter Turn air to power head off.
Bleed fluid pressure from
system. Unscrew tank
from filter. Clean tank,
screen and core with
solvent. Clean inside of
filter body. With special
red grease, wipe O-ring,
inside of body and external
threads on body.
Reassemble filter; hand
tighten tank’ slowly open
air to power head valve.
Unit is now ready to