Liquid Controls DB Manager - Manual (Page 14)

14
regIsTer aPPlICaTIon
Registering applications on DBManager entails mapping
the file path to the master database on the computer
and the databases on the DMS and LCR 600 units in the
network.
To register the application in db manager:
1. From the Setup Database Manager window, under
Registered Applications , click Add.
2. From the Add Application window, enter a name for the
application network in the Application Name: field.
3. From the Add Application window, click the small folder
icon to the right of the Path of Master Files on Office
PC field and, in the Browse for Master Files Folder
window navigate to the folder where the master database
files are saved. The file path can also be entered into the field
manually.
4. From the Add Application window, enter the file path of
the databases on the DMS and LCR 600 units. See note
below.
Browse for Master Files Folder
Add Application
seTuP -
dbmanager
regIsTer fIle server nodes
Registering the files server nodes in the network entails
identifying the node of each DMS and LCR 600 in the
fueling system and entering them into DBManager.
To register the dms and lCr 600 units in
dbmanager:
1. Click the DBManager icon.
2. From the Database Manager window, click
Setup.
3. From the Setup Database Manager window, under
Registered Filed Server Nodes , click Add.
4. In the Register New Node window, type a name for the
DMS or LCR 600 in the Node Name: field. (ex: Truck 1)
5. If setting up a cellular network, enter the IP address of the
modem connected to the unit in the Node IP Address:
field. If using serial communication, this field should be set to 0.0.0.0.
6. In the Node Number: field, enter the node of the unit .
7. Repeat steps 3-6 until each DMS and LCR 600 in the
fueling network is registered.
Value must match the LCP Node Address: in the Setup
LCP File Server (2/3) window of each DMS unit in the
network and the Unit ID: in the General Setup 1 screen
on each LCR 600 in the network.
After a node is registered, DBManager will
create a database folder for the device (node) in
C:\DMS, named by the name of the device.
File paths are set in the Office Path: field in the
System Utilities (2/3) window on the DMS and the
Office Path: field in FlightConnect Setup on the LCR
600. The DMS file path should be C:\DMS. The LCR
600 file path should be A:\.
Register New Node
Registered Nodes