Lectrosonics VRFIELD (Narrowband) - Manual (Page 9)

Digital Hybrid Wireless™ Modular Receiver System
Typical.Lectrosonics Audio Output Wiring Diagrams
Antenna.Combinations
ALP.Series
RA500
SNA600
4. Insert a charged battery into the front panel, or plug
the VR Field power supply into a suitable outlet
and plug the power connector into the Power Input
Jack (unscrew the power connector that goes to the
battery). Repeat for each VR Field System being
Typical USB Hookup for Single VR Field System
Coaxial.
Patch.Cables.
(Not.Supplied)
Antenna.Inputs
RS-232.Port USB.Port.on.VR.Field.
System.Rear.Panel
installed.
5. Turn down the audio inputs on all the externally
connected equipment, then connect them to the ap­
propriate Audio Output XLR Jacks.
6.
7.
If the VR Field System is to be set up using a com­
puter system using a USB interface, connect a USB
cable between the USB connector on the rear panel
of the VRF and the computer system or a USB hub
connected to the computer system.
Refer to “Setting Up the VR Field System via the
USB Port”.
USB.Port.on
Computer.System
Typical USB Hookup for Multiple VR Field Systems
USB.Port.
on.VR.FIeld.
System.Rear.
Panel
USB.Port.on.
Computer.
System
Audio.Output.XLR.Jacks
Rio Rancho, NM