Lectrosonics VRFIELD (Narrowband) - Manual (Page 15)

Digital Hybrid Wireless™ Modular Receiver System
1. Verify that the compatibility modes of the receiver
modules match the associated transmitters and that
the transmitters are of the same type and model.
2. Setup the transmitters according to the manufactur­
er’s recommendations.
3. Navigate to the DivMode Setup Screen.
4. Plug a set of headphones into the front panel
PHONES jack to monitor the blended output. (It
is also possible to monitor the output via external
equipment plugged into a rear panel XLR jacks cor­
responding to one of the members of the frequency
diversity pair.)
INVT.(Shown.in.Off.Position.
5. Monitor the blended output while adjusting the Mic
Level controls (audio volume) of one of the trans­
mitters. If the output does not null, then reset the
transmitter’s Mic Level control and press the Func­
tion button to invert (INVT) the audio output phase
on the second receiver of the Frequency Diversity
pair. Repeat the procedure until the deepest null is
achieved.
6. Press the Function button to ensure the INVT func­
tion is in the Off position.
7. Repeat Steps 1 through 7 for each receiver module
pair set to Frequency Diversity Mode.
Rio Rancho, NM 1