Lectrosonics VRFIELD (Narrowband) - Manual (Page 6)

VR Field
VR Field System Controls and Functions
Front Panel
LEVEL.Control.for.
PHONES.jack
LCD.Screen
PHONES.Jack
Function.Button
PUSH.FOR.MENU/SELECT.
Rotary.Control
POWER.Button BACK.Button Receiver.Select.
Buttons
Front Panel Controls and Functions
The VR Field System consists of a chassis (host as­
sembly) and one to six individual receiver modules.
The front panel provides an easy-to-use LCD interface
for system setup, monitoring and troubleshooting. Dur­
ing normal operation, the LCD shows RF and audio lev­
els, diversity status, pilot tone status (where applicable)
and transmitter battery status (when available) for all six
receivers at the same time. Individual screens for each
receiver are also available to provide additional informa­
tion and adjustments.
A headphone jack and level control is provided for indi­
vidual channel monitoring.
POWER Button
The POWER button is used both to control the applica­
tion of power to the unit and to clear (or reset) the Scan
Mode spectrum analyzer.
Pressing and holding the POWER button for at least
two seconds turns the unit off.
Function Button
Used for special functions in selected Setup Screens.
LCD Screen
The LCD Screen is a graphics-type Liquid Crystal Dis­
play used to set up and monitor system operation. (See
Setup and Operation Using LCD.)
NP1.Type.Battery Dust.Cover
PUSH FOR MENU/SELECT Rotary Control
The PUSH FOR MENU/SELECT (hereafter called
the MENU/SELECT control) is a dual function control
for navigating and selecting Setup Menus or Setup
Screens, and for setting parameters within the Setup
Screens.
LEVEL Control
The LEVEL control is used to adjust the output level of
the front panel PHONES jack.
PHONES Jack
The stereo PHONES jack is provided for monitoring the
audio output of selected receivers. Only the audio from
a single receiver (or a diversity pair) selected via the
Receiver Select Buttons will be present at this jack at
any given time.
Receiver Select Buttons
The six Receiver Select Buttons are used to select in­
dividual installed receiver modules either for monitoring
via the PHONES jack, or for setup and adjustment.
BACK Button
The Back Button is used to return to the previous menu
or setup screen.
Pressing the BACK button from the SetUpRx menu
returns to whatever screen was active prior to entering
SetUpRx.
LECTROSONICS, INC.