Alamo Eagle 20 - Manual (Page 98)

ASSEMBLY
Eagle 20 03/09 Assembly Section 3-12
© 2009 Alamo Group Inc.
ASSEMBL
Y
Driveline Clamp Cone Yoke Operating Instructions
Loosen the yoke clamp cone with a 11/16” (17mm)
wrench and remove the cone from yoke. Slide yoke
onto the shaft and align hole for clamping cone with
annular groove of gearbox shaft. Reinstall cone
and tighten (75 lb-ft torque). Push and pull the
driveline to ensure it is securely attached to the
shaft. Regularly check the driveline yoke to ensure
a tight connection. To remove the yoke, remove the
connecting cone and pull yoke off the shaft. If the
cone cannot be easily removed by hand, drive it out
from the other side using a hammer and punch.
NOTE: The clamping cone is serviced only as a
complete assembly. Do not attempt to disassemble
the clamping cone.
Canopy Shields
After final adjustment attach Canopy Shields over Divider Gearbox (FIGURE 26) , Secondary Gearbox
(FIGURE 24 & 25).
Install all Canopy Shields over Torque Limiters and Drivelines and make certain they remain
installed at all times when operating this Cutter.