Alamo Eagle 20 - Manual (Page 141)

OPERATION
Eagle 20 03/09 Operation Section 4-41
© 2009 Alamo Group Inc.
OPERA
T
ION
10.6 Shutting Down the Implement
To shut down attached mower head, first bring the
tractor to a complete stop. Decrease engine RPM
to idle then disengage cutterhead. The mower head
will come to a complete stop within a suitable
amount of time. Do not engage or disengage the
cutterheads at a high RPM unless there is an
emergency situation.
Park the tractor on a level surface, place the
transmission in park or neutral and apply the
parking brake, lower the attached implement to the
ground, shut down the engine, remove the key, and
wait for all motion to come to a complete stop
before exiting the tractor. OPS-U- 0016
11. DISCONNECTING THE MOWER FROM THE TRACTOR
Before disconnecting the mower, the PTO must be disengaged and blade rotation at a complete stop. Move
the mower to a level storage location and lower the center section and both wings to the ground. If the mower
will be stored with the wings in the raised position, install both wing transport lock braces. If the mower is not
resting securely on the ground, block the mower up securely before attempting to disconnect it from the
tractor.
Use extreme care to keep feet and hands from under the mower and clear of any pinch points. OPS-R-0030
Always shut the Tractor completely down, place the transmission in park, and set the
parking brake before you or anyone else attempts to connect or disconnect the Implement
and Tractor hitches.
(S3PT-15)