Alamo Eagle 20 - Manual (Page 93)

ASSEMBLY
Eagle 20 03/09 Assembly Section 3-7
© 2009 Alamo Group Inc.
ASSEMBL
Y
TIRES AND WHEELS
Before installing any tires and wheels make certain the Cutter is jacked up high enough and is securely
supported. When installing a segmented or Airplane tire, be sure the flat side of the lug nut is against the
Wheel. When installing a implement tire place conical side of lug nut against wheel.There are only three types
of tires that can be used on this cutter DO NOT USE ANY OTHER TYPE OF TIRE OR WHEEL, such as
automotive tires and rims. DO NOT EXCEED THE MAXIMUM SPEED FOR EACH TYPE OF TIRE. As
excessive speed can cause damage to the machine, tire, and wheel. When installing Sectional Tires and
Wheels note the direction of travel and the curvature of rubber segments in the tire and install as shown in
FIGURE 10. Do not exceed 15 M.P.H. on Sectional Tires. When removing Airplane Tires, let all of the air out of
the tire before removing lug nuts or wheel bolts or nuts. Do not exceed 20 M.P.H. on Airplane or Rib Implement
Tires.