Alamo Eagle 20 - Manual (Page 172)

MAINTENANCE
Eagle 20 03/09 Maintenance Section 5-22
© 2009 Alamo Group Inc.
MAINTENANCE
STEP 3
Laying the Hub Assembly on its side, tap the Gear end of the Output Shaft into the Gear and Bearing. Once
the Shaft has cleared the Bearing, it can be fully removed from the Hub Assembly. The remaining Bearings and
Bearing Cups can be removed by conventional means. FIGURE Mnt-R-0050.
STEP 4
Remove all eight Bolts from Input Cap using a 14mm Socket. Then using a Hammer, tap the Output end of the
Input Shaft. This will loosen the input Cap and allow the removal of the complete Input Shaft Assembly.
FIGURE Mnt-R-0051.