Controlled Products Systems Group 9050-080 - Manual (Page 49)

5.3 ACCESSORIES
The following accessory items can be used with the model 9100 slide gate operator.
Contact Sensor Contact sensors for use as a secondary entrapment protection device.
Miller Edge, Inc. ME120, ME123, MG020, MGR20, MGS20
Photo Cell Non-contact (photo cells) sensors for use as a secondary entrapment
protection device. Compliant with UL 325 and listed.
Infrared Thru-Beam with hoods and heater. 165-foot sensing distance.
P/N 8080-010
Photo-Reflective with reflector. 30-foot sensing distance.
P/N 8080-011
Loop Detector Detectors plug directly into ports on circuit board simplifying wiring.
P/N 9405-010 - Single channel detector.
P/N 9406-010 - Two channel detector
Loop Wire 18 AWG loop wire with XLPE insulation is ideal for ground loops.
Available in 500 and 1000 foot rolls with red, blue or black insulation.
Pre-Fab Loops Prefabricated ground loops. 24-foot circumference with 50-foot lead-in.
Available in yellow, red or blue jackets. Not for use in asphalt roadways.
Loop Test Meter Meg-ohm meter checks the integrity of ground loops.
P/N 9401-045
Time Clock 7 day and 365 day time clocks can be used to automatically open gate at
pre-set time and days. Compact clock fits inside the operator.
P/N 2600-791 – 7-day clock.
P/N 2600-795 – 365-day clock.
Surge Devices High and low voltage surge suppressers help prevent circuit board failure
caused by lightning strikes and power surges.
P/N 1876-010 - High Voltage.
P/N 1878-010 - Low Voltage.
Gate Scale Use to test ft/pounds required to move gate. P/N 2600-225
Speed Bumps Prefabricated six-foot speed bump reduces traffic speed through gate
system. P/N 1610-150
Endless Idler Use when gate operator is rear or center mounted. P/N 2600-818
Base Plate Required if operator is to be post mounted. P/N 2600-418
Nickel Chain Nickel plated chain.
P/N 2600-443 (10 ft. #41)
P/N 2600-444 (10 ft. #40)
Stainless Chain Stainless steel chain.
P/N 2600-475 (20 ft. #41)
39