CognitiveTPG A799 - Manual (Page 81)

Chapter 4: Programming Commands 81 Revision D 12/09
A799-PG00001D
Related information
This command is utilized in the TPG LogoEZ ® utility. The utility can be used to pre-configure new printers with a default
colorization setup without requiring any application changes. The default setup was designed to provide a general level of
colorization features that would not affect the printer operation. You can expand beyond the default features of the utility
by modifying the application at the host. However, do not attempt to modify the settings within the utility.
f = 1: s = 1H
a = 30H
f = 2: s = 32H
r = 19H
f = 3: s = 1H
r = 7H
t = 1H
f = 4: s = 30H
a = A0H
Convert 6-dots/mm bitmap to 8-dots/mm bitmap
ASCII US EOT n
Hexadecimal 1F 04 n
Decimal 31 04 n
Value: 0 = Off
1 = On
(When 0 and 1 are the LSB)
Default: 0 (Off)
Selects or cancels 6-dot/mm emulation mode.
When the 6-dot/mm emulation is selected, logos and graphics are expanded horizontally and vertically during download
to emulate their size on a 6-dot/mm printer. The horizontal positioning commands also emulate positioning on a 6-dot/mm
printer.
Enable constant speed logos
ASCII US { n
Hexadecimal 1F 7B n
Decimal 31 123 n
Value: 0 = disable
1 = enable
This command allows the firmware to determine
the optimal speed to print a logo. It is set prior to
downloading the logo and reset after the logo has been downloaded.
In general, “Set max target speed (1D A0 nl nh)” is the preferred command.