CNB HDF1212 - Manual (Page 13)

13
2-3. Start the System
Connecting the power cord will turn on DVR. The system initialization will take approximately 10 to 20
seconds. Once the system is initialized, it will display quad screen, and begin to record video automatically.
To turn off the system, select SHUTDOWN under main menu (MENU >
SHUTDOWN) and unplug the power cord when the shutdown message appears.
2-4. Menu Bar
The menu bar will appear on the bottom of the screen as shown below.
: Pressing the Menu will bring up the main menu list
“%”: Shows the % of HDD being used
: Turns on when the HDD is set to be overwritten.
: Turns on when the system is connected to the network
: Turns on when the Alarm is being activated
2-5. Display Icons
: Recording : No Recording
: Event Recording : Pre Event Recording
: Motion Detection : Sensor Detection
: Sequence : PTZ Camera
icon indicates that pre-event-recording is set – not saving data at the HDD.
Once, event is detected,
icon changes to , and it starts to record videos.