Connecting to an xdsl/cable modem – CNB ID2810PVF User Manual
Page 14
XNET Network Dome Camera User’s Guide
device, refer to the support document
[Use of Private IP network using IP-sharing-
device]
found on the Download Section of the CNBTEC web site.
②
3.2. Connecting to an xDSL/Cable Modem
1. Follow through steps 1 through 4 in Section 2.5 to assign IP address and other network
parameters to XNET.
2. Install XNET and connect it to xDSL or Cable modem as in Figure 3-2.
IP Network
(LAN/WAN)
xDSL/
Cable
Modem
Client PC
XNET
Figure 3-2. Connecting the XNET to ADSL/Cable Modem
When a static IP address is assigned to the xDSL or Cable modem, using IP-installer,
invoke the same method as “assigning an IP address on a LAN.” To enable email
notification of IP address changes assign a “send to” e-mail address using IP-installer.
When connecting XNET/XNET-Wireless to xDSL or Cable modem, usually a
straight LAN cable is required. But since some modems have crossover
connections, in this case, you should use a crossover LAN cable. Please contact
your service provider for detailed information.
14 of 44