CNB ID2810PVF - Manual (Page 11)

XNET Network Dome Camera User’s Guide
2) If you have standard power connect the network camera and PC as illustrated in
Figure 2-6.
LAN Hub
100BaseT
PC
XNET
DC In
AC In
AC Adaptor
Figure 2-6. Connecting Network camera and PC without using PoE
: CNBTEC does not support standard PoE. Do not connect the
network camera directly to a hub supporting standard PoE.
② Apply power to XNET
③ Install “IP installer” and “XNET-NVR” on your PC.
Detailed information for installing these programs can be found in
[IP-Installer User’s
Guide] and [XNET-NVR User’s Guide] , respectively.
④ Assign IP address to XNET using IP installer.
Identify the type of the network environment and set up IP address. Detailed process of
setting up IP address can be found in
[IP-Installer User’s Guide] . If network type is
xDSL or Cable modem you need supplementary information provided by your ISP.
⑤ Connect to XNET in Administrator Mode for initial parameter set-up.
The factory default state affords the ability to connect and configure the device in low
bandwidth environments. To configure the system for your environment use the
administration mode. Find detailed information for using administration mode in
section 5:
Configuring XNET in Administrative Mode . The following set-up table briefly defines
setup parameters. For detailed information see: Section 5, Configuring XNET in
Administrative Mode]
[Note]: Set-up values are preserved even when the power is turned off.
Page Parameter Setup value Factory default value
Video Size
Sets transmit video resolution,
XNET. Basic
Setup
Max Upload
Rate
Set this value smaller than the
uplink speed of your network.
NOTE: In order to “Save”
the values the user must
press the Check Button to
calculate the maximum
11 of 44