INTELLINET NETWORK 560900 24 Ports Gigabit + 4 Gigabit SFP PoE+ Web Management Ethernet Switch User Manual - Manual (Page 35)

34
4.2.6 Ping
This command sends ICMP echo request packets to another node on the network.
Ping Parameters
 Target IP Address: IP address of the host.
 Count: Number of packets to send. (Range: 1-20)
 Time Out: Sets the time period the host will be pinged.
Use the ping command to see if another site on the network can be reached.
The following are some results of the ping command:
 Normal response: The normal response occurs in 1 to 10 seconds, depending on network
traffic.
 Destination does not respond: If the host does not respond, a “timeout” appears in 10
seconds.
 Destination unreachable: The gateway for this destination indicates that the destination is
unreachable.
 Network or host unreachable: The gateway found no corresponding entry in the route table.
Press to stop pinging.