INTELLINET NETWORK 560900 24 Ports Gigabit + 4 Gigabit SFP PoE+ Web Management Ethernet Switch User Manual - Manual (Page 27)

26
Queue Mode:
 Strict: Services the egress queues in sequential order, transmitting all traffic in the
higher-priority queues before servicing lower-priority queues.
 WRR: Weighted Round-Robin shares bandwidth at the egress ports by using scheduling
weights with default values of 1, 2, 4, 8 for queues 0 through 7, respectively. (This is the
default selection.)
* Note: WRR can only be selected if Jumbo Frame mode is disabled on the Port
Configuration screen.
4.1.11 Filter Configuration
There are three modes that you can choose for filter configuration:
Disabled: When this mode is disabled, there is no protection here.
Static: The IP address you entered here can’t access the switch.
DHCP: The IP address retrieved from the DHCP server can’t access the switch.
4.1.12 PoE (Power over Ethernet) Configuration
PoE technology is a system to pass electrical power safely, along with data, on Ethernet
cabling. Power is supplied in common mode over two or more of the differential pairs of wires
found in the Ethernet cables and comes from a power supply within a PoE-enabled networking
device (such as a switch) or can be injected into a cable run with a midspan power supply.
This screen shows the PoE status when connected or disconnected to the PD device.
 PoE Enabled: POE of the port is able to supply power to the attached PD (powered device).