Hellwig Air 6299 - Manual (Page 3)

Part A Air Spring Installation
1. Prepare vehicle for installation by chocking front tires and setting emergency
brake. Before starting installation, measure the distance from the top of rear
wheel to fender lip as shown. This is the original ride height of the vehicle.
Write this measurement down as this will be used to set the height of the air
springs later in the installation.
2. For ease of installation, posi-
tion the rear wheels on automo-
tive ramps. Ensure vehicle is
secure and disconnect shock
absorbers from rear axle. Raise
vehicle frame until coil springs
are unloaded. Support frame
with jack stands and remove
coil springs and insulators from
vehicle. Do not remove bump
stops from frame.
Remove insulators
from frame and axle
Measure this
distance
6299 ( R-6299) 02/26/2010