GxT V016-01, Ferret 16 GasLink II 5-Gas Analyzer - Manual (Page 9)

9
Program a Custom Header
Up to four lines of header information can be entered. The header
is created in the top two lines of the screen. The bottom two lines
contain the characters that may be used in the header and the
control characters. There are two cursors. The Placement Cursor
is the flashing box that indicates where the next character will be
placed. The Selection Cursor is the flashing underline. The arrows
are control characters used to move the placement cursor on the
header lines, and are not printable.
Use the arrow keys to move the Selection Cursor to one of the ar-
rows, and press NEXT to move the Placement Cursor left, right, up
or down. Use the arrow keys to move the Selection Cursor under
the character that you want to add. Pressing the NEXT key places
the character in the header at location of the Placement Cursor.
The arrow keys may be held to move rapidly among the character
choices. The NEXT key may be held to rapidly place many copies
of the same symbol.
Selecting the return arrow, and pressing NEXT saves the header
in memory and returns to the main menu.