GxT V016-01, Ferret 16 GasLink II 5-Gas Analyzer - Manual (Page 22)

22
SAFETY PRECAUTIONS
—Read All Instructions Before Using The Meter—
• Always wear eye protection when testing vehicles. Be extra careful
near batteries and moving parts. Do not lay tools on a battery.
• Battery gas is highly explosive.
a. If a battery explodes flush the acid away from persons skin with
generous amounts of water. Follow up with a neutralizing solution
of baking soda and then more water.
Treat clothing, vehicle parts, and equipment similarly. Any acid
traces inside equipment must be removed by generous rinsing.
Dry equipment and place in a warm 50°C (120°F) oven until
thoroughly dry.
b. Never use a wrench on the ungrounded battery terminal until
the grounded one has been disconnected. Contact between
the vehicle body metal and the hot terminal can cause sparks to
ignite gas or even weld tools into a battery short circuit.
c. Keep the space around a battery well ventilated.
d. Do not make sparks or allow flames near batteries.
• Before working on a vehicle set the brakes and block the wheels.
Beware of automatic parking brake releases.
• Keep your work area well ventilated and free of exhaust. Engine
exhaust contains deadly poisons. Treat Gas Detector exhaust and
drain hoses the same as the vehicle tailpipe. Both give off deadly
exhaust fumes.
• Avoid electrical shocks caused by getting close to live ignition wires
or touching the coil TACH terminal. A person’s reaction near a live
engine can be more damaging than the shock.
• Keep spark producing devices at least 0.5m (18”) above the floor to
reduce the hazard of igniting gasoline vapor.
• Do not let test leads wind up in a moving fan or pulley. Route leads
away.
• Remove finger rings and metal wrist bands. They can short terminals
and become very hot from electric current.