Gardner Bender 1 1_8 HP Titan Pumps - Manual (Page 8)

WARRANTY: GB ELECTRICAL, INC. warrants its
product against defects in workmanship and materials
for 1 year from date of delivery to user. Chain is not
warranted. Warranty does not cover ordinary wear
and tear, abuse, misuse, overloading, altered products
or use of improper fluid. WARRANTY RETURN PROCEDURE: When
question of warranty claim arises, send the unit to the
nearest GB Authorized Service Center for inspection,
transportation prepaid. Furnish evidence of purchase
date. If the claim comes under the terms of our
warranty the Authorized Service Center will REPAIR
OR REPLACE PARTS AFFECTED and return the
unit prepaid. PARTS AND SERVICE: For quality workmanship and
genuine GB ELECTRICAL parts, select an Authorized
GB Service Center for your repair needs. Only
repairs performed by an Authorized Service Center
displaying the official GB Authorized sign are backed
with full factory warranty. Contact GB Electrical
(414) 352-4160 for the name of the nearest GB
Authorized Service Center.
REPAIR AND SERVICE INSTRUCTIONS: For repair service and parts, contact your nearest GB ELECTRICAL
Service Center. The GB ELECTRICAL Service Center will provide complete and prompt service on all GB
ELECTRICAL products.
GB Electrical, Inc.
An Applied Power Company 6101 N. Baker Road, Milwaukee, WI 53209
Phone: (414) 352-4160
FAX (414) 352-2377
RPS-0103 9/95
■
MAINTENANCE
■ Check Oil Level
Check reservoir hydraulic oil level before every use. Remove the oil level gauge and add oil through the
opening in the top of the reservoir. IMPORTANT: Add oil only when all system components are in the fully
retracted position. If oil is added when plungers are advanced, there will be more oil in the system than the
pump can hold. When cylinders are retracted, oil in the hoses and cylinders will be returned and the
reservoir will be over filled.
IMPORTANT: You will need a new reservoir gasket
to reassemble the pump after changing the oil.
1. Completely drain and clean the reservoir after
every 100 hours of operation. Refill with new GB
Electrical hydraulic oil. If pump is used
infrequently, clean the reservoir once a year.
NOTE: This procedure requires that you remove the
pump from the reservoir. Work on a clean bench
and use proper oil disposal methods.
2. Remove the 10 screws holding the pump to the
reservoir. After these screws are removed, one
of the shroud brackets will be loose. It is best to
lift the pump off of the reservoir by holding the
cover plate.
3. Carefully set the pump down without
damaging filter screens.
4. Remove the reservoir gasket and discard it.
5. Pour all oil out of reservoir. Thoroughly clean the
reservoir by wiping and rising with a
suitable solvent.
6. Use a soft bristle brush and solvent to clean the
three filter screens.
7. Reassemble the pump and reservoir, installing a
new gasket.
8. Fill the reservoir with new GB Electrical
hydraulic oil.
If the pump requires repair work, contact your
local Authorized GB Electrical Service Center.
■
Change Oil and Clean Reservoir