Gardner Bender BOS(A)57 No-Dog Offset Bender - Manual

Gardner
Bender
Instruction
Sheet
BOS57 / BOSA57
No-Dog
Offset Bender
IMPORTANT: RECEIVING INSTRUCTIONS: Visually inspect all components for shipping damage. If any shipping
damage is found, notify carrier at once. Shipping damage is NOT covered by warranty. The carrier is responsible for
all repair or replacement costs resulting from damage in shipment.
IMPORTANT USER SAFETY AND PROTECTION: In setting up systems to fit your operations, care must be taken to
select the proper components and design to insure appropriate integration with your operations and existing
equipment and that all safety measures have been taken to avoid the risk of personal injury and property damage
from your application or system.
GB ELECTRICAL, INC. CANNOT BE HELD RESPONSIBLE FOR DAMAGE OR INJURY CAUSED BY UNSAFE
USE, MAINTENANCE OR APPLICATION OF ITS PRODUCTS. Please contact GB's technical service department
for assistance if you are in doubt as to the proper safety precautions essential to designing and setting up your
particular application.
! CAUTION
Model BOS57 and BOSA57 are designed for bending 1 ⁄
2
" EMT, IMC, Rigid and 3 ⁄
4
" EMT Conduit.
ATTEMPTS TO BEND ANY OTHER SIZES OR TYPES OF CONDUIT WILL DAMAGE THE BENDER
AND VOID ALL WARRANTY.
! IMPORTANT
TO AVOID POOR QUALITY BENDS, BE SURE BRACKET TO FRAME MOUNTING HARDWARE IS
TIGHTENED SNUGLY TO PREVENT SIDE-TO-SIDE MOVEMENT. CHECK HARDWARE PERIODICALLY
OR IF EXCESS BRACKET MOVEMENT IS ENCOUNTERED.
Upon initial receipt
1
Fully assembled
ZRPS-0135 3/29/00 4:02 PM Page 1