Serial port connection – ADIC FCR 200 User Manual
Page 58

4-18
Installation
62-9301-01
Serial Port Connection
The RJ11 connector on the rear panel of the FCR200 provides
an RS-232 connection that can be used to configure the
FCR200, monitor diagnostic status, or to update the program
stored in the FCR200’s Flash memory. A cable is provided
with the unit to connect to a DB-9 serial connection. Further
information on the operations allowed via the RS-232 port is
provided in Chapter 6.
The RS-232 port operates with the following settings:
Baud Rate:
Autobaud (9600, 19200, 38400, 57600, or
115200)
Data Bits:
8
Stop Bits:
1
Parity:
None
Flow Control:
None
Figure 4-16
FCR200 Serial Port