ADIC FCR 200 - Manual (Page 48)

4-8 Installation
62-9301-01
Slide Rail Mounting (Optional)
1 Locate the front of the mounting brackets
Figure 4-5 Front of Mounting Brackets
2 Attach the brackets to the front mounting rails,
using two torx screws on each side. Be sure to use
only the top and bottom holes in each bracket. (The
middle holes will be used to attach the front cover
panel after the unit is installed.) Tighten the screws
securely.
WARNING To reduce injury or equipment damage, the
mounting bracket must be level. If the
brackets are not level, the FCR200 cannot
be installed properly.