Apple Color StyleWriter 2500 - Manual (Page 24)

24 Chapter 2
Loading the sheet feeder
The sheet feeder holds paper, envelopes, or other materials and feeds them
automatically into the printer. To load the sheet feeder, follow these steps:
1 Remove any paper or other materials that you don’t want to use.
2 Adjust the external paper selector, as shown in the next step.
It’s important to adjust the selector before loading the new material into the
sheet feeder.
3 Load the paper or other materials.
IMPORTANT Don’t mix envelopes with paper in the feeder.
Before inserting the material,
move the paper selector lever
to the envelope icon (
E ) for
envelopes and to the paper
icon (
«
) for everything else.
Insert envelopes this way.
(Make sure the flap is
smoothed flat.)
Slide this guide so
it just touches the
edge of the paper.
If the stack of paper bows
out even slightly,
the guide is too tight.
Insert letterhead paper face up
with the top of the page pointing
downward.
Insert three-hole punched paper so
that the holes line up along this side.
Don’t stack paper above this line ( ).
Make sure the paper lines up
evenly at this side of the feeder.
Extend this paper support.
Make sure the paper extends
above the support (and doesn’t
slide down inside the printer).