Flowline LI40-1001 PodView - Manual (Page 2)

2 of 16 MN204260 Rev A
INTRODUCTION / TABLE OF CONTENTS Step One
The general purpose indicator displays tank level or volume in engineering units with 1‐4 relay status
indicators, and is compatible with any EchoPod level sensor that's been configured with WebCal 6 software
and updated to V50 firmware or higher. Powered by EchoPod, the field mount indicator may be located up to
4.5m (15') from the sensor. PodView requires no programming. The indicator repeats the measured value,
applicable relay status and set point configuration of the attached sensor. If EchoPod relay set point changes
are desired, they can be easily made through the field indicator.
Table of Contents
Specifications: ......................................................................................................................................................... 3
Dimensions: ......................................................................................................................................................... 3
Components: .............................................................................................................................................. 3
Safety Precautions: ................................................................................................................................................ 4
Getting Started: ...................................................................................................................................................... 5
Wiring:
......................................................................................................................................................... 6
Adding a Loop Powered Display: ............................................................................................................... 6
Understanding EchoPod®: ..................................................................................................................................... 7
Liquid Height vs. Volume: .......................................................................................................................... 7
Linear vs. Non‐Linear: ................................................................................................................................ 8
Example #1 (Volume Output): ....................................................................................................... 8
Example #2 (Current Output): ....................................................................................................... 9
Relay Settings: ......................................................................................................................................... 10
Installation: ....................................................................................................................................................... 11
PodView® Getting Around: .................................................................................................................................. 12
Menu: ....................................................................................................................................................... 12
Changing a Pump Set Point: ..................................................................................................................... 13
Changing an Alarm Set Point: .................................................................................................................. 14
Troubleshooting .................................................................................................................................................... 15
Display Descriptors: .................................................................................................................................. 15
Warranty, Returns and Limitations ....................................................................................................................... 16